IC-W32A

一般規格

我們的四級認証規格當然和以下的資料會有一點出入, 不過我們還是列出國際上的完整現行規格以供讀者參考, 如果還有其它的疑問以認証的編號為主

頻率範圍 (Unit: MHz)

　 VHF UHF
U.S.A. Tx:144-148 Rx: 118-174*1 Tx:440-450 Rx: 400-470*2
Europe 144-146 430-440
Asia Tx: 144-148 Rx: 118-174*1 430-440
Australia 144-148 430-440
Italy Tx; 144-148 Rx: 136-174*1 Tx: 430-440 Rx:400-470*3
*1 Guaranteed 144-148; *2Guaranteed 440-450; *3Guaranteed 430-440

由於業餘無線界的玩家們都知道無線電是可以經由修改線路而得到更大的頻寬或功率, 在學理上我們也會提供這些技術性的資料供給要對無線設備有進一步的玩家作為學術上的參考, 不過一但經過修改後, 將終結該機的所有售後服務, 以上有 * 號的範圍為設備保証範圍.

由於頻率必須配合天線的諧振, 否則使用易導致功率組件的損毀, 若您不諳於無線電的使用, 不應任意修改其線路, 而且使用規定以外的頻率於法不容.

Mode: FM, (U.S.A./Asia versions, AM Rx 118-136 MHz)
Acceptable power supply : 4.5 to 16 V DC (negative ground)
Number of memory channels: 200 plus 2 call, 20 scan edges and 4 DTMF
Tuning steps: 5, 10, 12.5, 15, 20, 25, 30 and 50 kHz
Useable temperature range : -10°C to +60°C; (+14°F to +140°F)
Frequency stability: ± 5 ppm (0°C to +50°C;)
Current drain (at 13.8 V DC)

　

　 VHF UHF
Tx HIGH 1.6 A 1.5 A
LOW 500 mA 600 mA
Rx Rated audio 210 mA
Power saved 40 mA

　

Dimensions (w/BP-180 or BP-173):
57(W) x 137(H) x 33(D)mm
2 1/4(W) x 5 13/32(H) x 1 5/16(D)in
Weight (BP-173 and antenna): 450g (1lb)

Transmitter

Output power (at 13.5 V DC): 5 W or 500 mW
Modulation system : variable reactance frequency modulation
Max. frequency deviation : ± 5.0 kHz
Spurious emissions : Less than -60 dB
External mic connector : 3-conductor, 2.5(d) mm (1/10")/ 2 ohms

Receiver

Receive system: Double conversion superheterodyne
Intermediate frequencies(1st/2nd)MHz:
VHF 30.85/0.45
UHF 46.05/0.45
Sensitivity (for 12 dB SINAD):
original band operation - 0.16 µV
opposite band operation - 0.32 µV
Squelch Sensitivity: Less than 0.16 µV
Spurious and image rejection ratio:
More than 60 dB (VHF)
More than 50 dB (UHF) (except 1/2 IF and 2nd image)
Audio output power(at 13.8 V DC): More than 180mW (10% distortion with an 8-ohm load)
External speaker connector: 3-conductor, 3.5(d) mm (1/8")/ 8 ohms

All stated specifications are subject to change without notice or obligation.

附件

電池及護套
BP-171 4.8 V, 700 mAh
BP-173 9.6 V, 650 mAh
BP-170 R6 (AA) batteries x 4
BP-172 4.8 V, 950 mAh
BP-180 7.2 V, 600 mAh

估計功率輸出及操作的時間 (在t 25°C, 以最高輸出 (high power): Rx:待機比=1:1:8)

　 BP-171 BP-172 BP-173 BP-180
VHF 1.5 W/4.5 h 1.5 W/6.0 h 5.0 W/3.0 h 3.5 W/3.0 h
UHF 1.3 W/6.0 h 1.3 W/7.5 h 4.5 W/3.5 h 3.5 W/3.5 h

　

BC-119 桌上型快充器 + AD-51 充電源轉換器 CHARGER ADAPTER
對 BP-171, BP-172, BP-173 or BP-180 可快速充電. 交直流兩用. 另備用 220VAC AD-75 可供擇購.
CP-12/L 點煙哭供電線 + 電源雜訊濾除器 OPC-254/L
Allows you to operate the transceiver through a 12 V cigarette lighter socket or 4.5 to 16 V external DC power supply with the CP-12/L or OPC-254/L, respectively. The connected battery pack is charged simultaneously (12 to 16V DC required).
MB-30 車上手機固定座
For mounting the transceiver on the inside door panel of a vehicle.
手機外接麥克風喇叭
HM-46 Compact and lightweight. Equipped with an earphone jack.
HM-46 Durable, full-sized speaker-microphone.
HM-46 Allows you to remotely select memory channels, operating frequency, etc. Simple remote and normal remote are selectable.
HS-85 HEADSET
Allows you hands-free operation. Includes VOX, PTT, "one-touch PTT" (TOT).
SP-13 EARPHONE
Provides clear audio in noisy environments.
BC-110A/D/V WALL CHARGER
Regularly charges battery packs. The same as supplied with some versions
CS-W32 CLONING SOFTWARE + OPC-478 CLONING CABLE
Provides quick and easy programming of items, including memory channels, memory names and set mode contents, for local repeater frequencies, etc.
OPC-474 CLONING CABLE
Used for handheld-to-handheld data cloning
LC-128 CARRYING CASE
Useable with any battery pack.